nblida.com
ENCNES

DOWNLOAD SAMPLE

News

The composition of the air source processor and its instructions for use

Update:18 Mar 2021
Summary:

The composition of the air source processor includes an […]

The composition of the air source processor includes an air filter, a pressure reducing valve and a lubricator. Some brands of solenoid valves and cylinders can achieve oil-free lubrication (relying on grease to achieve lubrication), so there is no need to use a lubricator! The filtration degree is generally 50-75μm, and the pressure adjustment range is 0.5-10Mpa. If the filtration precision is 5-10μm, 10-20μm, 25-40μm, and the pressure adjustment is 0.05-0.3Mpa, 0.05-1Mpa, there are three three pieces without tube The connected components are called triples. The three major pieces are indispensable air source devices in most pneumatic systems. They are installed near the air-using equipment and are the final guarantee for the quality of compressed air. The installation sequence of the three major parts is air filter, pressure reducing valve and lubricator according to the intake direction. The combination of the air filter and the pressure reducing valve can be called a pneumatic two-piece. The air filter and the pressure reducing valve can also be assembled together to become a filter pressure reducing valve (the function is the same as the combination of the air filter and the pressure reducing valve). In some occasions, the oil mist in the compressed air cannot be allowed, and an oil mist separator must be used to filter out the oil mist in the compressed air. In short, these components can be selected according to needs, and they can be combined for use.
The air filter is used to clean the air source. It can filter the moisture in the compressed air and prevent the moisture from entering the device with the gas.
The pressure reducing valve can stabilize the air source, keep the air source in a constant state, and reduce the damage to hardware such as valves or actuators due to sudden changes in the air pressure of the air source. The filter is used to clean the air source. It can filter the water in the compressed air and prevent the water from entering the device with the gas.
The lubricator can lubricate the moving parts of the body, and can lubricate the parts that are inconvenient to add lubricating oil, which greatly extends the service life of the body.
installation
Instructions for use of air source treatment parts
1. Filter drainage has two methods: differential pressure drainage and manual drainage. When manually draining water, it must be drained before the water level reaches the level below the filter element.
2. When adjusting the pressure, please pull up and then rotate before turning the knob, and press down the rotary knob for positioning. Rotate the knob to the right to increase the outlet pressure, and rotate it to the left to decrease the outlet pressure. When adjusting the pressure, it should be gradually and evenly adjusted to the required pressure value, and should not be adjusted in one step.
3. How to use the oil feeder: Use JIS K2213 oil for the oil feeder (ISO Vg32 or equivalent oil). Please do not fill the cup more than eighth full. The number 0 is the smallest amount of oil, and 9 is the largest amount of oil. It cannot be rotated from the 9-0 position and must be rotated clockwise.
Main supply: air source two-pieces, 4V series solenoid valves, SC cylinders, two-pieces, three-pieces, hand-switching valves, PC connectors, PU pipes, pressure reducing valves and other pneumatic joints

Ningbo Lida Pneumatic Complete Co., Ltd is professional pneumatic cylinder Manufacturers in China, visit https://www.nblida.com/

 

0

Recommended Products

LD2 Series pneumatic air control solenoid valve
M5 Locking Fitting
Magnetic Switch CS1 S1
Hand-Pull Valve